Save 20% On Your First Autoship Order

Day
:
:
Online since 2002 |   866-316-0162

View product option

Ez-Access Ramp Hanger

Authorized Retailer
Product Option

Ramp Hanger

SKU PRHP
$33.29 Pair
Request quote

Ez-Access Ramp Hanger secures ramp to platforms. It is designed to be used with Ez-Access Modular Ramps. If a ramp must be angled when attaching to a platform, an upper transition or lower transition with an MRST must be used instead of a Ramp Hanger. The same components can be used at the top and bottom of the ramp or ramp runs depending on the angle required.

$46.65

Total: $33.29

Earn $1.00 in HPFY rewards

What to buy with Ez-Access Ramp Hanger?


How to Install Ez-Access Ramp on Platforms?

  • Locate MRHP. Install two hangers onto the side of the platform where the ramp will be attached.
  • Hold the hanger perpendicular to the platform side rail then bring the hanger upward until it is against the side rail lip. Rotate the hanger and continue pushing upward in such a manner that the “hook" at the top of the hanger goes behind and catches on the lip at the top of the platform side rail and the hanger sits on the ledge at the bottom.
  • Set the ramp on the hangers. The hangers should be positioned as close as possible to the ramp side rails. The procedure is the same at both the top and bottom of ramp runs which end at a platform unless a transition plate is used.

WARNING: Do not attempt to walk on ramps until installation is complete.


Securing Ramps to Platforms


  • After all ramps and platforms have been positioned and all handrails and/or connectors, and end loops have been installed, ramps must be secured to platforms with clips
  • Use two clips at all locations where a ramp meets a platform.
  • Position the clip so that the long side is as close as possible and parallel to the ramp side rail with the clip edge extending onto the ramp side rail by approximately 5/16"
  • Drill 1/8" pilot holes centered on the ramp side rails and 5/16" from the edge of the platform side rail then use the 1/4" x 1" long self-drilling, self-tapping screws to secure the clip to the platform side rail.

Product Videos

Related Articles

{{x.Heading}}

{{x.ShortDescription}} ...

Share

EZ Ramp Hanger Reviews

Please enter your and your friends email address below.

Fields marked with * are compulsory

Your Name*
Your Email Address
Friend's Name*
Friend's Email Address
Message
The selected product information along with Reward Dollar coupon code has been successfully emailed to you and your friend.

Thank you for using www.healthproductsforyou.com

Close