AMFAB EZ Table

More Information

• Tools Required:
  - Phillips screwdriver
  - (2) 7/16" wrenches
• Assembly Instructions:
  1. Place the base under the left side of chair with the magazine rack opening facing the rear of chair. Place the front left leg of the chair on the positioning pad located near the magazine rack.
  2. Stand the Column on end, making sure the Trip Rod is visible in the rectangular tube but not protruding out of the top. If necessary, shake the Column until the rod drops.
  3. Insert Trip Handle into the Column with the rounded side up. Be sure that the Trip Handle rests on top of the rod inside the Column foot
  4. Place the Top on a flat surface, with the Top Bracket facing upward. Then, while holding the Trip Handle in place so it does not fall out, insert the Column into the Top Bracket. Align the holes in the Column foot, the Trip Handle and the Top Bracket. Install both bolts and both nuts through these aligned holes with the two (2) 7/16" wrenches.
  5. Pick up the Top and Column and place over the round tube on the Base inside of the magazine rack. Be sure the Column has dropped down all the way!
  6. Remove the black shipping screw in the column and replace it with the zinc plated screw, using a Phillips screwdriver.
• Operating Instructions:
  A. To elevate the table, push upwards at any position on the underside of the top, until the top has reached the desired height.
  B. To lower, squeeze the trip handle up towards and push the top down to the desired height. The table will operate best if the downward pressure is placed at the column end of the top.
  C. Occasional application of light oil lubrication between the inner and outer columns will help keep your Over Bed Table operating smoothly. Penetrating oils with rust inhibitors are recommended.
  D. The table will swing a full 360 degrees around on the base to be used as an end table or a lap tray as needed.

Specification

Customer Reviews